ISIS_1.3.6.1.3.37.2.0.1 isisDatabaseOverload

Description

ISIS/3/OLOAD:OID [oid] The overload state of IS-IS LSDB changed. (sysInstance=[integer], sysInstanceofLevel=[integer], sysLevel=[integer], overLoadState=[integer])

The database entered or exited from the Overload state.

Attribute

Alarm ID	Alarm Severity	Alarm Type
1.3.6.1.3.37.2.0.1	Minor	other(1)

Parameters

Name	Meaning
oid	Indicates the MIB object ID of the alarm.
sysInstance	Indicates the ID of the IS-IS process.
sysInstanceofLevel	Indicates the ID of the IS-IS process.
sysLevel	Indicates the IS-IS level: 1: Level-1 2: Level-2
overLoadState	Indicates the LSDB Overload state: 1: off 2: on 3: waiting 4: overloaded

Impact on the System

1. If the trap is triggered by the change of the LSDB Overload state, route selection of the neighbor will be affected.

2. If the trap is triggered by memory failure, it indicates that the IS-IS database is unauthentic.

Possible Causes

1. The set-overload or undo set-overload command is run in the IS-IS view.

2. Memory application failed because memory was insufficient. As a result, the system of the switch may crash.

Procedure

Run the display this command in the IS-IS view to check whether the set-overload command has been run in this process.
- If so, this trap message is informational only, and no action is required. Go to Step 6.
- If not, go to Step 2.
Run the display history-command command in any view to check whether the undo set-overload command has been run in the process.
- If the undo set-overload command has been run in the process, go to Step 6.
- If the undo set-overload command has not been run in the process, go to Step 3.
Run the display memory-usage command to check the memory usage of the switch. Check whether the memory usage reaches the threshold.
- If so, go to Step 4.
- If not, go to Step 5.
Obtain the logs.
Collect alarm information and configuration information, and then contact technical support personnel.
End.

Related Information

None