L3AD/4/RESOURCE_FULL

Message

L3AD/4/RESOURCE_FULL: The resource of the table on the chip is not enough.(Type=[STRING])

The entry resources of a chip are allocated, and the current resources are insufficient.

Parameter Name	Parameter Meaning
Type	entry type of a chip, including: L3INTF: layer-3 egress entry L3EGRESS: next-hop entry L3ECMP: next-hop group entry

The usage of entry resources is beyond the range. It is recommended that some resources be released.

Perform the following operations based on the chip entry type in the alarm:
If the number of Layer 3 egress entry resources is not enough, delete redundant VLANIF and tunnel interfaces.

If the number of next-hop entry resources is not enough, shut down certain egresses.

If the number of next-hop group entry resources is not enough, delete certain equivalent routes. In case of static routes, you can delete some unnecessary routes. In case of dynamic routes, you can run the maximum load-balancing command to reduce the maximum number of equal-cost routes.
If the fault persists, collect log information and configuration information, and then collect log information and configuration information, and then contact technical support personnel. You can collect diagnostic information using the display diagnostic-information command.