LACP_1.3.6.1.4.1.2011.5.25.41.3.34 hwLacpPartnerExpiredLoss

Description

LACP/2/PEL:OID [oid] The member of LAG receive expired PDU from partner. (TrunkIndex=[INTEGER], PortIfIndex=[INTEGER], TrunkId=[INTEGER], TrunkName=[OCTET], PortName=[OCTET])

The local end received a timeout packet from the remote end.

Attribute

Alarm ID	Alarm Severity	Alarm Type
1.3.6.1.4.1.2011.5.25.41.3.34	Major	other(1)

Parameters

Name	Meaning
oid	Indicates the MIB object ID of the alarm.
TrunkIndex	Index of an Eth-Trunk interface in static LAC mode
PortIfIndex	Index of an Eth-Trunk member interface in static LAC mode
TrunkId	ID of an Eth-Trunk interface in static LAC mode
TrunkName	Name of an Eth-Trunk interface in static LAC mode
PortName	Name of an Eth-Trunk member interface in static LAC mode

Impact on the System

Partial or all link bandwidth will lose, causing partial or all services to be interrupted.

Possible Causes

The remote end could not receive the LACP packet from the local end.

Procedure

If both local and remote ends are Huawei Datacom devices, see the troubleshooting procedures in LACP_1.3.6.1.4.1.2011.5.25.41.3.2 hwLacpNegotiateFailed.
1. Check whether the interface is Down.
  - If so, go to Step 2.
  - If not, go to Step 4.
2. Run the undo shutdown command to check whether the alarm is cleared.
  - If the alarm is cleared, go to Step 8.
  - If the alarm is not cleared, go to Step 3.
3. Check whether the physical link is faulty.
  - If so, go to Step 6.
  - If not, go to Step 4.
4. Check whether there is an interface on the local or remote end of the link leaving the LAG.
  - If so, go to Step 5.
  - If not, go to Step 7.
5. Check whether the interface leaves the LAG normally.
  - If so, go to Step 8.
  - If not, go to Step 7.
6. Repair the physical link and then check whether the alarm is cleared.
  - If the alarm is cleared, go to Step 8.
  - If the alarm is not cleared, go to Step 4.
7. Collect alarm information and configuration information, and then contact technical support personnel.
8. End.
If the local end is a Huawei Datacom device, but the remote end is a non-Huawei Datacom device, contact technical personnel from the device's manufacturer.