NQA_1.3.6.1.4.1.2011.5.25.111.6.8 nqaHTTPStatsThresholdNotification

Description

NQA/4/HTTPTHRESHOLD:OID [oid] NQA entry over threshold. (OwnerIndex=[OCTET], TestName=[OCTET])

Indicates that the period of a test exceeded the set threshold. The threshold could be set by the user. The threshold rtd command could modify the threshold.

Attribute

Alarm ID	Alarm Severity	Alarm Type
1.3.6.1.4.1.2011.5.25.111.6.8	Warning	environmentalAlarm(6)

Parameters

Name	Meaning
oid	Indicates the MIB object ID of the alarm.
OwnerIndex	Indicates the administrator of an NQA test.
TestName	Indicates the name of an NQA test instance.

Impact on the System

None.

Possible Causes

This trap occurred in the NQA test.

The threshold was set too small.

The network was busy.

Procedure

Run the display cpu-usage command in the system view to check whether the CPU has an excessive load.
- If so, go to Step 3.
- If not, go to Step 2.
In the NQA test view, run the display this command to know the current threshold. Then run the threshold rtd command to modify the threshold as required. The recommended value is 20 ms.
Perform the test again to check whether the alarm is cleared.
- If so, go to Step 4.
- If not, go to Step 3.
Collect alarm information and configuration information, and then contact technical support personnel.
End.

Related Information

None