POE_1.3.6.1.4.1.2011.5.25.195.40.22 hwPoeRpsPowerOutputAlarm

Description

POE/3/RPSALM: OID [oid] RPS power cannot provide PoE power for this device. (DevID=[INTEGER])

An alarm is generated when the RPS power fails to provide full power for the connected PoE device.

Attribute

Alarm ID	Alarm Severity	Alarm Type
1.3.6.1.4.1.2011.5.25.195.40.22	Minor	equipmentAlarm(5)

Parameters

Name	Meaning
oid	Indicates the MIB object ID of the alarm.
DevID	Indicates the device ID.

Impact on the System

PDs may fail to be powered on because of insufficient PoE power.

Possible Causes

The RPS power is the hot backup power for PoE devices and provides full power for a maximum of two PoE switches. If there are more than two PoE switches, the remaining PoE switches generate an alarm, indicating that the RPS power cannot provide full PoE power.

Procedure

Check whether a hot-swappable 4815 power module is installed in every power slot on the RPS.
- If not, install a 4815 power module in every power slot.
- If so, go to step 2.
Check whether the PDs connected to the PoE device need to be powered on.
- If so, connect these PDs to the PoE device that can provide power normally.
- If not, the alarm handling ends.