PTP_1.3.6.1.4.1.2011.5.25.187.5.1 hwPtpPortStateChange

Description

PTP/4/PORTSTATECHANGE:OID [oid] The state of port [ULONG] changed.(portname=[STRING], currentstate=[STRING], oldstate=[STRING]).

The interface status was changed.

Alarm ID	Alarm Severity	Alarm Type
1.3.6.1.4.1.2011.5.25.187.5.1	Warning	equipmentAlarm(5)

Name	Meaning
[oid]	Indicates the MIB object ID of the alarm.
[ULONG]	ID of the interface whose status was changed
portname	Name of the interface whose status was changed
currentstate	Status of the interface, including: Master Slave Passive Listening Faulty Initializing Premaster Disabled Uncalibrated
oldstate	Old status of the interface, including: Master Slave Passive Listening Faulty Initializing Premaster Disabled Uncalibrated

None.

Run the display ptp all command in any view to check whether a faulty PTP interface exists.
- If a PTP interface is in the faulty state, the link is faulty or the PTP interface is Down. In this case, go to Step 3.
- If no PTP interface is in the faulty state, go to Step 2.
Run the display this and display ptp all config commands in the interface view to check PTP configurations. Compare the PTP configurations with the previous configurations and check whether the clock attributes of the PTP device and interface have been changed.
- If the clock attributes of the PTP device and interface have been changed, go to Step 4.
- If the clock attributes of the PTP device and interface have not been changed, go to Step 3.
Collect alarm information and configuration information, and then contact technical support personnel.
End.