SECE/4/SPECIFY_SIP_ATTACK

Message

SECE/4/SPECIFY_SIP_ATTACK: The specified source IP address attack occurred. (Slot=[STRING], SourceAttackIP=[STRING], AttackProtocol=[STRING], AttackPackets=[ULONG] packets per second)

Description

The attack source is displayed when a device is attacked.

Parameters

Parameter Name	Parameter Meaning
Slot	Indicates the slot ID if stacking is not configured. Indicates the stack ID if stacking is configured.
SourceAttackIP	Indicates the source IP address of an attack.
AttackProtocol	Indicates the protocol type of attack packets.
AttackPackets	Indicates the rate of attack packets, in pps.

Possible Causes

A lot of attack packets from the corresponding IP address were received on the interface.

Procedure

Run the display auto-defend attack-source command to check whether the user attack packets exist.
If so, run the auto-defend action deny [ timer time-length ] command to discard the attack packets.
If the fault persists, collect log information and configuration information, and then contact technical support personnel. You can collect diagnostic information using the display diagnostic-information command.