SW_SNPG/4/RPC_FAIL:Failed to send the configuration
to LPU because of the failure of RPC. (Slot=[STRING])
Description
Configuration cannot be delivered because of RPC failure.
Parameters
Parameter Name
Parameter Meaning
[STRING]
Indicates the slot ID.
Possible Causes
The board is not registered.
The RPC channel is blocked.
Procedure
Run the display device command to check
whether the member switch has registered.
If so, go to step 3.
If not, go to step 2.
If the member
switch has not registered, RPC communication fails, which is
normal. This log is informational only, and no action is required.
Collect log information about RPC message sending failures
of the member switch, and contact technical support personnel. You can collect diagnostic information using the display diagnostic-information command.