WLAN_1.3.6.1.4.1.2011.6.139.16.1.1.1.1 hwRadioChannelChangedTrap

Description

WLAN/4/RADIO_CHANNEL_CHANGE:OID [oid] Channel of radio is changed. (APMAC=[OPAQUE], RadioID=[INTEGER], APName=[OCTET], Channel1=[OCTET], Channel2=[OCTET], CauseId=[INTEGER], CauseStr=[OCTET], PreChannel1=[OCTET], PreC-hannel2=[OCTET], APID=[INTEGER], NewChannelHasRadarChannel=[OCTET])

The AP channel was changed.

Attribute

Alarm ID	Alarm Severity	Alarm Type
1.3.6.1.4.1.2011.6.139.16.1.1.1.1	Warning	environmentalAlarm(6)

Parameters

Name	Meaning
OID	Indicates the ID of the MIB object.
APMAC	Indicates the MAC address of an AP.
RadioID	Indicates the radio ID.
APName	Indicates the AP name.
Channel1	Indicates the actual working channel of the AP.
Channel2	Indicates the actual second working channel of the AP.
CauseId	Indicates the channel change reason. unknown(1) - The channel was changed due to an unknown reason. dfs(2) - The channel was changed due to Dynamic Frequency Selection (DFS). wds(3) - The channel was changed due to WDS network establishment. config(4) - The channel was changed due to manual configurations. calibrate(5) - The channel was changed due to radio calibration. thirdGPP(6) - The channel was changed due to 3GPP base station notification.
CauseStr	Indicates a character string describing channel change reasons.
PreChannel1	Indicates the channel before change. NOTE: When an AP goes online on an AC for the first time, the channel of the AP before change is not saved on the AC. Therefore, when a channel change alarm is generated for the first time, the original channel of the AP is displayed as - in the alarm.
PreChannel2	Indicates the second channel before the channel is changed.
APID	Indicates the AP ID.
NewChannelHasRadarChannel	Indicates whether radar channels exist among the changed channels.

Impact on the System

The working channel of the AP was changed, which may affect the other APs.

Possible Causes

Cause 1: The radio was calibrated.

Cause 2: Users changed the channel.

Cause 3: Radar signals conflicted.

Cause 4: The channel changed in WDS mode.

Cause 5: The channel changed in Mesh mode.

Procedure

No action is required.

Related Information

None.