< Home

WLAN_1.3.6.1.4.1.2011.6.139.16.1.1.1.7 hwNerborInterfDetectedTrap

Description

WLAN/4/AP_ADJACENT_CHANNEL_INTERFERENCE: OID [oid] The adjacent-channel interference exceeds the alarm threshold.(APMAC=[OPAQUE], RadioID=[INTEGER],APName=[OCTET], APChannel=[INTEGER], APID=[INTEGER], IntfBssId=[OPAQUE], IntfChnl=[INTEGER], RSSI threshold percent=[INTEGER]%)

Adjacent-channel interference between APs was detected.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.6.139.16.1.1.1.7 Warning equipmentAlarm(5)

Parameters

Name Meaning
oid Indicates the ID of the MIB object.
APMAC Indicates the MAC address of an AP.
RadioID Indicates the radio ID.

APName

Indicates the AP name.
APChannel Indicates the channel of a monitoring AP.
APID Indicates the AP ID.
IntfBssId Indicates the BSSID of the interfering AP.
IntfChnl Indicates the channel of the interfering AP.
RSSI threshold percent Indicates the RSSI threshold value on an interface, in percentage.

Impact on the System

The packet loss rate increases, the data rate decreases, and even the services may be interrupted.

Possible Causes

The alarm threshold for adjacent-channel interference was exceeded.

Procedure

  1. Run the display radio-2g-profile { all | name profile-name } and display radio-5g-profile { all | name profile-name } commands to view the value of Adjacent-channel frequency interference threshold(%) and check whether the alarm threshold for adjacent-channel interference is configured properly. It is recommended that you set the alarm threshold for adjacent-channel interference to 50.

    • If so, go to Step 3.
    • If not, go to Step 2.

  2. Run the interference adjacent-channel threshold threshold-value command to configure a proper alarm threshold for adjacent-channel interference. Then, check whether the alarm persists.

    • If so, go to Step 3.
    • If not, go to Step 5.

  3. If severe interference triggers local radio calibration, the channel and power are adjusted automatically. Then, check whether the alarm persists.

    • If so, go to Step 4.
    • If not, go to Step 5.

  4. Collect alarm messages, log messages, and configurations, and then contact the technical support personnel.
  5. End.

Related Information

None.

Copyright © Huawei Technologies Co., Ltd.
Copyright © Huawei Technologies Co., Ltd.
< Previous topic Next topic >