The acl ip-pool command creates an ACL IP address pool and enters the ACL IP address pool view.
The undo acl ip-pool command deletes an ACL IP address pool.
By default, no ACL IP address pool has been created on the device.
Product |
Support |
|---|---|
S5720-EI, S5720-HI, S5730-HI, S5731-H, S5731-S, S5731S-H, S5731S-S, S5732-H, S6720-EI, S6720-HI, S6720S-EI, S6730-H, S6730S-H, S6730-S, and S6730S-S |
Supported |
S2720-EI, S5720I-SI, S5720-LI, S5735-L, S5735S-L, S5735S-L-M, S5720S-LI, S5720S-SI, S5720-SI, S5735-S, S5735S-S, S5735-S-I, S5730S-EI, S5730-SI, S6720-LI, S6720S-LI, S6720S-SI, and S6720-SI |
Not supported |
Parameter |
Description |
Value |
|---|---|---|
acl-ip-pool-name |
Specifies the name of the ACL IP address pool to be created. |
The value is a string of 1 to 32 characters without spaces and starting with a letter. |
Usage Scenario
An ACL IP address pool applies when policy-based routing (PBR) is used to redirect packets to multiple next hops. An ACL IP address pool can be invoked by the redirect ip-multihop command to redirect packets to the next hop specified by the ACL IP address pool.
Follow-up Procedure
Run the ip-address (ACL IP address pool view) command multiple times to specify multiple IP addresses.
Precautions
The switch supports a maximum of 12 ACL IP address pools. Each ACL IP address pool supports a maximum of 4 IP addresses.
In the scenario when PBR is used to redirect packets to multiple next hops, if the device has no ARP entry matching the specified next hop IP address, the redirection does not take effect. The device still forwards packets to the original destination until the ARP entry matching the specified next hop IP address is generated on the device. You can run the display acl ip-pool command to check whether the next hop IP address specified in the ACL IP address pool takes effect.