arp regularly-refresh cycle-interval
Function
The arp regularly-refresh cycle-interval command sets the interval for updating ARP entries in the device hardware table.
The undo arp regularly-refresh cycle-interval command restores the default interval for updating ARP entries in the device hardware table.
By default, the interval for updating ARP entries in the device hardware table is 1 minute.
Only the S5720-HI, S5730-HI, S5731-H, S5731-S, S5731S-H, S5731S-S, S5732-H, S6720-EI, S6720-HI, S6720S-EI, S6730-H, S6730S-H, S6730-S, and S6730S-S support this command.
Format
arp regularly-refresh cycle-interval cycle-interval
undo arp regularly-refresh cycle-interval
Parameters
| Parameter | Description | Value |
|---|---|---|
cycle-interval |
Specifies the interval for updating ARP entries in the device hardware table. |
The value is an integer in the range from 1 to 1440, in minutes. The default value is 1. |
Usage Guidelines
Usage Scenario
After a device learns ARP entries, it saves them to the software table and then delivers them to the hardware table. If the entries in the hardware table are incorrect, packets cannot be forwarded normally. In this case, you can enable the function of periodically updating ARP entries in the device hardware table to correct the ARP entries so that packets can be forwarded normally. You can set the interval for updating ARP entries in the device hardware table as required.
Precautions
To reduce the load on a device, when the CPU usage reaches about 50%, the device does not periodically update ARP entries in the device hardware table.