assign resource-template acl-mode { nac | normal }
Function
The assign resource-template acl-mode command sets the ACL resource allocation mode.
The undo assign resource-template acl-mode command restores the default ACL resource allocation mode.
By default, the ACL resource allocation mode of is Normal.
Only the S2720-EI, S5720I-SI, S5720-LI, S5720S-LI, S5720S-SI, S5720-SI, S5730S-EI, S5730-SI, S6720-LI, S6720S-LI, S6720S-SI, and S6720-SI support this command.
Format
assign resource-template acl-mode { nac | normal } [ slot slot-id ]
undo assign resource-template acl-mode [ slot slot-id ]
Parameters
Parameter |
Description |
Value |
|---|---|---|
nac |
Specifies the NAC ACL resource allocation mode. |
- |
normal |
Specifies the Normal ACL resource allocation mode. |
- |
slot slot-id |
If slot-id is not specified, ACL resource allocation mode in all the stack switches is displayed. |
The value is determined based on the device configuration. |
Usage Guidelines
Usage Scenario
The default ACL resource allocation mode is Normal. In Normal mode, the ACL does not support matching of destination IPv6 addresses. If matching destination IPv6 address is required, switch the ACL resource allocation mode to NAC.
Precautions
- The ACL specifications in NAC and Normal ACL resource allocation modes are the same.
- In NAC mode, matching MAC addresses of IPv6 packets is not supported. As a result, the configuration of the corresponding function matching the source and destination MAC addresses of IPv6 packets in Normal mode may be lost or not take effect.
- After configuring the ACL resource allocation mode, save the configuration, and restart the device for the configuration to take effect.