bandwidth-config enable

Function

The bandwidth-config enable command enables a device to calculate the cost of an OSPF interface based on the configured interface bandwidth.

The undo bandwidth-config enable command disables a device from calculating the cost of an OSPF interface based on the configured interface bandwidth.

By default, a device is not enabled to calculate the cost of an OSPF interface based on the configured interface bandwidth.

Format

bandwidth-config enable

undo bandwidth-config enable

Parameters

None

Views

OSPF view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

External factors may affect the physical bandwidth of a link and change the physical bandwidth of an interface, thereby deteriorating network performance. To enable a device to adjust and optimize the route selection rules, run the bandwidth bandwidth command in the OSPF interface to adjust the interface bandwidth and run the bandwidth-config enable command to enable the device to calculate the cost of an OSPF interface based on the configured interface bandwidth. The calculation formula is as follows: Cost of the interface = Bandwidth reference value/Interface bandwidth.

Precautions

If the bandwidth command is not configured, the OSPF interface cost is calculated based on the physical bandwidth of the interface.
If the bandwidth-config enable command is not configured, the OSPF interface cost is calculated based on the physical bandwidth of the interface.

Example

# Enable a device to calculate the cost of an OSPF interface based on the configured interface bandwidth.

<HUAWEI> system-view
[HUAWEI] ospf 100
[HUAWEI-ospf-100] bandwidth-config enable