ble source

Function

The ble source command configures a global source IP address in packets sent by an AC to a location server.

The undo ble source command deletes a global source IP address from packets sent by an AC to a location server.

By default, the source IP address is not configured in packets sent by an AC to a location server, and the IP address of the route outbound interface is used as the source IP address.

Format

ble source ip-address ip-address

undo ble source

Parameters

Parameter	Description	Value
ip-address ip-address	Specifies a source IPv4 address in packets sent by an AC to a location server.	The value is in dotted decimal notation.

Views

WLAN view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

In Bluetooth location scenarios, you can run the ble source command to configure a source IP address in packets sent by an AC to a location server.

Run the ble source command to configure different source IP addresses for the active and standby ACs.

When source IP addresses are configured on an AC using the ble source and source commands at the same time, the source IP address configured using the source command takes effect.

Precautions

Ensure that the AC IP address manually configured on the location server is the same as that configured using the ble source command.
The source IP address must exist on the AC; otherwise, the configuration does not take effect.

Example

# Configure 10.102.25.23 as the source IP address of the packets sent from the AC to the location server.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] ble source ip-address 10.102.25.23