bpdu-tunnel vlan (upgrade-compatible command)

Function

The bpdu-tunnel vlan command enables VLAN-based Layer 2 protocol tunneling on an interface.

bpdu-tunnel { all | protocol-type &<1-15> } vlan { low-id [ to high-id ] } &<1-10>

Parameter	Description	Value
all	Enables or disables transparent transmission of packets of all standard Layer 2 protocols and user-defined Layer 2 protocols.	-
protocol-type	Enables or disables transparent transmission of packets of a specified Layer 2 protocol. You can specify multiple protocols in the command.	-
low-id	Specifies the start VLAN ID.	The value is an integer that ranges from 1 to 4094. The value must be smaller than the end VLAN ID.
high-id	Specifies the end VLAN ID.	The value is an integer that ranges from 1 to 4094. The value must be greater than the start VLAN ID.

Ethernet interface view, XGE interface view, GE interface view, Eth-Trunk interface view, port group view

2: Configuration level

This command is available to aid upgrade compatibility. It can be run when it is entered in full.

After the upgrade, it is replaced by the l2protocol-tunnel vlan command.