calibrate reference data-analysis

Function

The calibrate reference data-analysis disable command disables Big Data calibration on radio interfaces of APs and AP groups.

The calibrate reference data-analysis enable command enables Big Data calibration on radio interfaces of APs and AP groups.

The undo calibrate reference data-analysis command restores the default Big Data calibration configuration on radio interfaces of APs and AP groups.

By default, Big Data calibration is disabled on radio interfaces of APs but enabled on radio interfaces in an AP group.

Format

calibrate reference data-analysis { disable | enable }

undo calibrate reference data-analysis

Parameters

None

Views

AP group radio view, AP radio view

Default Level

2: Configuration level

Usage Guidelines

After Big Data calibration is enabled, the device performs calculation based on the variations in interference and load according to Big Data information obtained from the CampusInsight. This function helps better avoid interference and improve network capacity. If the Big Data calibration function is disabled, radio calibration is performed based only on the locally collected data.

The Big Data calibration function takes effect on an AP only when the following configurations are performed:

Configure the function of reporting KPIs to the Big Data analyzer.
Enable radio calibration.
Run the undo calibrate reference data-analysis command in the WLAN view to enable the global Big Data calibration function.
Enable the Big Data calibration function on the AP. (If the Big Data calibration function is not configured on a single AP, the configuration of the AP group takes effect.)

Example

# Enable Big Data calibration on radio 0 in AP group ap-group1.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] ap-group name ap-group1
[HUAWEI-wlan-ap-group-ap-group1] radio 0
[HUAWEI-wlan-group-radio-ap-group1/0] calibrate reference data-analysis enable