netconf register abort

Function

The netconf register abort command terminates a switch's registration with iMaster NCE-Campus.

The undo netconf register abort command resumes a switch's registration with iMaster NCE-Campus.

By default, a switch registers with iMaster NCE-Campus normally.

Format

netconf register abort

undo netconf register abort

Parameters

None

Views

System view

Default Level

3: Management level

Usage Guidelines

Usage Scenario

When a switch fails to register with iMaster NCE-Campus, log in to the switch through SSH to view the registration status. If the registration process is not terminated, the DHCP server may re-assign an IP address to the switch, which will cause the SSH login process to terminate. To prevent this problem, log in to the switch and then run the netconf register abort command to terminate the registration process.

After this command is executed, the registration process stops for 30 minutes and then resumes. To view the registration status, run the display netconf connect-status command.

Precautions

The netconf register abort command cannot be executed repeatedly.
Do not run this command when the switch has registered with iMaster NCE-Campus successfully.
The command configuration is not recorded to the configuration file and the command will become ineffective after the switch restarts.

Example

# Terminate the switch's registration with iMaster NCE-Campus.

<HUAWEI> system-view
[HUAWEI] netconf register abort