Configuring VCT on an Interface

This section describes how to configure virtual cable test (VCT) on an interface using the rpc method.

**Table 1** Configuring VCT on an interface
Operation	XPATH
rpc	/huawei-ethernet:virtual-cable-test/input/ifname

Data requirement

Item	Data	Description
Interface	GigabitEthernet0/0/1	VCT is configured on the interface.

Request example

<?xml version="1.0" encoding="UTF-8"?>
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="2ac0550f-49dc-11e7-b586-f0bc1781395f">
  <hw-ethernet:virtual-cable-test xmlns:hw-ethernet="urn:huawei:params:xml:ns:yang:huawei-ethernet">
    <hw-ethernet:ifname>GigabitEthernet0/0/1</hw-ethernet:ifname>
  </hw-ethernet:virtual-cable-test>
</rpc>

Response example

Sample of successful response

<?xml version='1.0' encoding='UTF-8'?>
<rpc-reply xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="2ac0550f-49dc-11e7-b586-f0bc1781395f">
  <result>
    <virtualcabletest-state-result>
      <virtualcabletest-pairastatus>normal</virtualcabletest-pairastatus>
      <virtualcabletest-pairbstatus>normal</virtualcabletest-pairbstatus>
      <virtualcabletest-paircstatus>normal</virtualcabletest-paircstatus>
      <virtualcabletest-pairdstatus>normal</virtualcabletest-pairdstatus>
      <virtualcabletest-pairalength>0</virtualcabletest-pairalength>
      <virtualcabletest-pairblength>0</virtualcabletest-pairblength>
      <virtualcabletest-pairclength>0</virtualcabletest-pairclength>
      <virtualcabletest-pairdlength>0</virtualcabletest-pairdlength>
    </virtualcabletest-state-result>
  </result>
</rpc-reply>

Sample of failed response

<?xml version='1.0' encoding='UTF-8'?>
<rpc-reply xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="cfc47140-49dc-11e7-8c66-f0bc1781395f">
  <rpc-error>
    <error-message>valid user-defined rpc fail.</error-message>
  </rpc-error>
</rpc-reply>