Setting CFM Parameters
Procedure
- Setting the RMEP activation time
Run system-view
The system view is displayed.
Run cfm md md-name
The MD view is displayed.
Run ma ma-name
The MA view is displayed.
Run active time time
The RMEP activation time is configured.
IEEE 802.1ag has two versions: IEEE 802.1ag Draft 7 and IEEE Standard 802.1ag-2007. This command can be used only on the device running IEEE Standard 802.1ag-2007. Before setting the RMEP activation time, you must use the cfm version command to set the Ethernet CFM version to IEEE Standard 802.1ag-2007.
- Setting the anti-jitter time during alarm restoration
Run system-view
The system view is displayed.
Run cfm md md-name
The MD view is displayed.
Run ma ma-name
The MA view is displayed.
Run alarm finish time time
The anti-jitter time during alarm restoration is configured.
IEEE 802.1ag has two versions: IEEE 802.1ag Draft 7 and IEEE Standard 802.1ag-2007. This command can be used only on the device running IEEE Standard 802.1ag-2007. Before setting the anti-jitter time during alarm restoration, you must use the cfm version command to set the Ethernet CFM version to IEEE Standard 802.1ag-2007.
- Setting the anti-jitter time during alarm generation
Run system-view
The system view is displayed.
Run cfm md md-name
The MD view is displayed.
Run ma ma-name
The MA view is displayed.
Run alarm occur time time
The anti-jitter time during alarm generation is configured.
IEEE 802.1ag has two versions: IEEE 802.1ag Draft 7 and IEEE Standard 802.1ag-2007. This command can be used only on the device running IEEE Standard 802.1ag-2007. Before setting the anti-jitter time during alarm generation, you must use the cfm version command to set the Ethernet CFM version to IEEE Standard 802.1ag-2007.