Creating a LAG

Procedure

1. Run system-view

   The system view is displayed.

2. Run interface eth-trunk trunk-id

   An Eth-Trunk is created and the Eth-Trunk interface view is displayed.

   If the specified Eth-Trunk already exists, this command directly displays the Eth-Trunk interface view.

   trunk-id defines the Eth-Trunk ID. The following is the value range of trunk-id for different models:

   • S2720-EI, S5720I-SI, S5720-SI, S5720-LI, S5720S-LI, and S5720S-SI: 0-119
   • S5720-EI, S5720-HI, S5730-HI, S5731-H, S5731-S, S5731S-H, S5731S-S, S5732-H, S5735-L, S5735S-L, S5735S-L-M, S5735-S, S5735-S-I, S5735S-S, S6720-EI, S6720-HI, S6720S-EI, S6730-H, S6730S-H, S6730-S, and S6730S-S: 0-127
   • S5730-SI, S5730S-EI, S6720-SI, S6720S-SI, S6720-LI, and S6720S-LI: 0-249

   On the S5731-H, S5731-S, S5731S-H, S5731S-S, S5732-H, S6730-H, S6730S-H, S6730-S, S6730S-S, S6720-EI, and S6720S-EI, you can run the assign trunk command to set the value, and run the display trunk configuration command to check the configuration.