(Optional) Setting the LACP Interface Priority

Procedure

1. Run system-view

   The system view is displayed.

2. Run interface interface-type interface-number

   The member interface view is displayed.

3. Run lacp priority priority

   The LACP priority of the member interface is configured.

   By default, the LACP interface priority is 32768. In priority comparisons, numerically lower values have higher priority.

   By default, the system selects active interfaces based on interface priorities. This may lead to low-speed member interfaces with high priorities being selected as active interfaces, providing less bandwidth for services. To select high-speed member interfaces as active interfaces, run the lacp selected { priority | speed } command to configure the system to select active interfaces based on the interface rate.

   

   If the max active-linknumber link-number command is run in the Eth-Trunk interface view, you need to run the lacp preempt enable command to enable LACP preemption on the current Eth-Trunk interface. Otherwise, interfaces with high LACP interface priorities may fail to be selected as active interfaces.