Entering the Interface View

Procedure

1. Run system-view

   The system view is displayed.

2. Run interface interface-type interface-number

   The interface view is displayed.

   interface-type interface-number specifies the type and number of an interface.

   

   If the specified interface does not exist, this command creates the interface and displays the interface view.

   • Only the S5720-EI, S5720-HI, S5730-HI, S5731-H, S5731-S, S5731S-H, S5731S-S, S5732-H, S6720-EI, S6720-HI, S6720S-EI, S6730-H, S6730S-H, S6730-S, and S6730S-S support Ethernet sub-interfaces.

   • Only hybrid and trunk interfaces on the preceding switches support Ethernet sub-interface configuration.

   • After you run the undo portswitch command to switch Layer 2 interfaces on the preceding series of switches into Layer 3 interfaces, you can configure Ethernet sub-interfaces on the interfaces.

   • After an interface is added to an Eth-Trunk, sub-interfaces cannot be configured on the interface.

   • VLAN termination sub-interfaces cannot be created on a VCMP client.