Enabling the Service Loopback Function on an Eth-Trunk
Context
Before enabling the service loopback function on an Eth-Trunk, note that only one interface enabled with the service loopback function is needed on a device. The interface must be idle and not transmitting services.
Procedure
- Run system-view
The system view is displayed.
- Run interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
- Run service type tunnel
The Eth-Trunk is enabled with the service loopback function.
You cannot configure both the service type tunnel command and the URPF function on the same Eth-Trunk.
On an Eth-Trunk enabled with the service loopback function, the STP function is automatically disabled. After the service loopback function is disabled on the Eth-Trunk, the STP function is automatically enabled.
- Run quit
Return to the system view.
- Run interface interface-type interface-number
The interface view is displayed.
- Run eth-trunk trunk-id
The interface is added to the Eth-Trunk.