Configuring a Principal VLAN for MUX VLAN

Procedure

1. Run system-view

   The system view is displayed.

2. Run vlan vlan-id

   A VLAN is created and the VLAN view is displayed. If the VLAN already exists, the VLAN view is displayed.

   The VLAN ID is in the range 1 to 4094. To create VLANs in a batch, run the vlan batch { vlan-id1 [ to vlan-id2 ] } &<1-10> command. Then run the vlan vlan-id command to enter the view of a specified VLAN.

   

   If a switch is configured with multiple VLANs, configure names for the VLANs to facilitate VLAN management.

   Run the name vlan-name command in the VLAN view. After a VLAN name is configured, you can run the vlan vlan-name vlan-name command in the system view to enter the corresponding VLAN view.

3. Run mux-vlan

   The VLAN is configured as a principal VLAN.

   The VLAN ID assigned to a principal VLAN cannot be used to configure the super-VLAN or sub-VLAN. Additionally, it is not recommended that this VLAN ID be used to configure VLAN mapping and VLAN stacking.