Configuring Interface-based Multicast VLAN Replication
Configuration Procedure
Interface-based multicast VLAN replication implements multicast service isolation in the same user VLAN and improves control on multicast service flows.
Currently, the switch supports interface-based multicast VLAN replication only on IPv4 networks. This function must be used with Internet Group Management Protocol (IGMP) snooping. The configuration of interface-based multicast VLAN replication is similar to the configuration of multicast VLAN replication based on user VLANs, except that IGMP snooping does not need to be enabled in user VLANs. You only need to run the vlan vlan-id command to create user VLANs.
Perform the configuration in the listed sequence: