A UDP Jitter Test Instance Fails to Be Started
Context
A UDP jitter test may fail to be started. This fault is commonly caused by incorrect settings of mandatory parameters of the test instance.
Generally, the following commands are used in the NQA view. Only the display commands can be used in any view.
Procedure
- Run the display nqa-agent admin-name test-name [ verbose ] command on the NQA client or run the display this command
in the NQA view to check whether the test type is Jitter.
- If so, go to Step 2.
- If not, run the test-type jitter command to set the test type to UDP Jitter.
- Run the display nqa-agent admin-name test-name [ verbose ] command on the NQA client or run the display this command
in the NQA view to check whether the destination IP address is configured.
- If so, go to Step 3.
- If not, run the destination-address ipv4 ip-address command in the NQA test instance view to configure the destination IP address.
- Run the display nqa-agent admin-name test-name [ verbose ] command on the NQA client or run the display this command
in the NQA view to check whether the destination port is configured.
If not, run the destination-port port-number command in the NQA view to configure the destination port.