Verifying the Configuration of Control Parameters for Join/Prune Messages

Prerequisites

After control parameters for Join/Prune messages are configured, you can check information about the PIM interface, statistics about PIM control messages, and PIM routing table.

Procedure

Run the display pim [ vpn-instance vpn-instance-name | all-instance ] interface [ interface-type interface-number | up | down ] [ verbose ] command to check PIM information on an interface.
Run the following commands to check the number of sent or received PIM control messages.
- display pim [ vpn-instance vpn-instance-name | all-instance ] control-message counters message-type { probe | register | register-stop | crp }
- display pim [ vpn-instance vpn-instance-name | all-instance ] control-message counters [ message-type { assert | graft | graft-ack | hello | join-prune | state-refresh | bsr } | interface interface-type interface-number ] ^*
Run the following commands to check the PIM routing table.
- display pim [ vpn-instance vpn-instance-name | all-instance ] routing-table [ group-address [ mask { group-mask-length | group-mask } ] | source-address [ mask { source-mask-length | source-mask } ] | incoming-interface { interface-type interface-number | register } | outgoing-interface { include | exclude | match } { interface-type interface-number | register | none } | mode { dm | sm | ssm } | flags flag-value | fsm ] ^* [ outgoing-interface-number [ number ] ]
- display pim [ vpn-instance vpn-instance-name | all-instance ] routing-table brief [ group-address [ mask { group-mask-length | group-mask } ] | source-address [ mask { source-mask-length | source-mask } ] | incoming-interface { interface-type interface-number | register } ] ^*