Creating a Static PW

Procedure

1. Run system-view

   The system view is displayed.

2. Run interface interface-type interface-number

   The AC interface view is displayed.

3. (Optional) On an Ethernet interface, run undo portswitch

   The interface is switched to Layer 3 mode.

   By default, an Ethernet interface works in Layer 2 mode.

   

   Only the S5720-EI, S5720-HI, S5730-HI, S5731-H, S5731-S, S5731S-H, S5731S-S, S5732-H, S6720-EI, S6720-HI, S6720S-EI, S6730-H, S6730S-H, S6730-S, and S6730S-S support switching between Layer 2 and Layer 3 modes.

4. Run mpls static-l2vc { { destination ip-address | pw-template pw-template-name vc-id } ^* | destination ip-address [ vc-id ] } transmit-vpn-label transmit-label-value receive-vpn-label receive-label-value [ tunnel-policy tnl-policy-name | [ control-word | no-control-word ] | [ raw | tagged ] ] ^*

   A static PW is created.

   

   When the AC interfaces are Ethernet interfaces, you can specify the parameters raw and tagged.

5. (Optional) Run mpls l2vpn service-name service-name

   A name is configured for the L2VPN service.

   After a name is configured for the L2VPN service, you can maintain the L2VPN service by clicking the name directly on the NMS GUI.