Enabling RIP on the Specified Network Segment

Context

After enabling RIP, specify the network segment where RIP runs. RIP runs only on the interfaces that reside on the specified network segment. RIP does not receive, send, or forward routes on the interfaces that do not reside on the specified network segment.

Procedure

Enable RIP to send and receive routes on the specified network segment.
1. Run system-view
  The system view is displayed.
2. Run rip [ process-id ]
  The RIP view is displayed.
3. (Optional) Run undo verify-source
  Source check is disabled for RIP packets.
  
  If IP addresses of devices on both ends of a P2P link belong to different network segments, the two devices cannot establish a neighbor relationship unless source check is disabled.
4. Run network network-address
  RIP is enabled on the specified network segment.
  - network-address specifies the address of a natural network segment.
  - An interface can be associated with only one RIP process.