(Optional) Configuring Forwarding Isolation Between AC Interfaces

Context

If multiple users are bound to the same VSI, you can use the isolate spoken command to enable forwarding isolation between AC interfaces. After this command is run, the VSI attribute of all AC interfaces in the VSI is spoke, preventing the users from communicating with each other.

Before configuring forwarding isolation between AC interfaces, the VPLS signaling configuration must have been completed.

For Martini VPLS, the pwsignal ldp and vsi-id vsi-id commands have been run.
For Kompella VPLS, the pwsignal bgp and route-distinguisher route-distinguisher commands have been run.
For BGP AD VPLS, the bgp-ad and vpls-id vpls-id commands have been run.

Only the S5720-HI, S5730-HI, S5731-H, S5731S-H, S5732-H, S6720-HI, S6730S-H and S6730-H support this function.

Procedure

Run system-view
The system view is displayed.
Run vsi vsi-name
The VSI view is displayed.
Run isolate spoken
Forwarding isolation between AC interfaces in the VSI is enabled.

By default, forwarding isolation between AC interfaces in a VSI is disabled.
Run quit
Return to the system view.
(Optional) If one AC interface wants to communicate with other AC interfaces in the same VSI, set the VSI attribute of this AC interface to hub.
1. Run interface interface-type interface-number
  The AC interface view is displayed.
2. Run hub-mode enable
  The VSI attribute of the AC interface is set to hub.