< Home

Verifying the VXLAN Configuration in Centralized Gateway Mode Using Static Mode

Context

After you complete configuring VXLAN service access points and VXLAN tunnels, run the following commands to verify the VXLAN configuration.

Procedure

  • Run the display bridge-domain [ bd-id [ brief | verbose ] ] command to view the BD configuration.
  • Run the display vxlan tunnel [ tunnel-id ] [ verbose ] command to view VXLAN tunnel information.
  • Run the display vxlan vni [ vni-id [ verbose ] ] command to view VXLAN configuration of a specified VNI or all VNIs.
  • Run the display vxlan peer [ vni vni-id ] command to view the destination VTEP IP address with a specified VNI.
  • Run the display vxlan encapsulation interface interface-type interface-number [ bridge-domain bd-id | default | dot1q [ vid pe-vid ] | qinq [ vid vlan-vid [ ce-vid ce-vid ] ] | untag ] command to view VXLAN encapsulation information about Layer 2 sub-interfaces of a main interface.
Parent Topic: Configuring VXLAN in Centralized Gateway Mode Using Static Mode
Copyright © Huawei Technologies Co., Ltd.
Copyright © Huawei Technologies Co., Ltd.
< Previous topic