Configuring Parameters for APs to Go Online

Procedure

1. Run system-view

   The system view is displayed.

2. Run wlan

   The WLAN view is displayed.

3. Run ap-id ap-id

   Run ap-mac ap-mac

   Or run ap-name ap-name

   The AP view is displayed.

4. Run ap-name ap-new-name

   A name is configured for an AP.

   By default, no AP name is configured for an AP.

   

   The new AP name cannot be the same as the existing AP name.

5. Run ap-group ap-group

   The AP group to which the AP belongs is modified.

   By default, no AP group is configured.

6. Run address-mode { dhcp | static }

   The mode in which the AP obtains an IPv4 address is configured.

   By default, the mode in which an AP obtains an IP address is not configured.

7. (Optional) Run ip-address ip-address { mask-length | mask } [ gateway gateway ]

   A static IPv4 address and gateway are configured for the AP.

   By default, no static IPv4 address and gateway are configured for an AP.

   

   This step is performed only if APs obtain IP addresses in static mode.

8. Run ac-list ipv4-address &<1-4>

   An AC IPv4 address list is configured for the AP.

   By default, no AC IPv4 address list is configured.

9. (Optional) Run management-vlan

   CAPWAP packets sent from the AP's wired interface are configured to carry a management VLAN tag.

   By default, CAPWAP packets sent from an AP's wired interface do not carry a management VLAN tag.