deception ip-state detect rate

Function

The deception ip-state detect rate command configures the frequency of scanning IP addresses by the switch.

The undo deception ip-state detect rate command restores the default frequency of scanning IP addresses by the switch.

By default, the switch scans IP addresses 30 times per second.

Format

deception ip-state detect rate rate-number

undo deception ip-state detect rate

Parameters

Parameter	Description	Value
rate-number	Specifies the frequency of scanning IP addresses by the switch.	The value is an integer in the range from 1 to 4096, in "times per second".

Views

Deception view

Default Level

2: Configuration level

Usage Guidelines

The switch initiates IP address scanning on the network segment to be detected to check whether IP addresses are online. If the scanning frequency is too high, the network is affected. If the scanning frequency is too low, the switch takes a long time to learn about the online status of IP addresses. You need to configure a proper IP address scanning frequency based on the site requirements and live network quality.

Example

# Set the frequency of scanning IP addresses by the switch to 40 times per second.

<HUAWEI> system-view
[HUAWEI] deception
[HUAWEI-deception] deception ip-state detect rate 40