(AP group radio view) The wids device detect enable command enables device detection on all specified radios in an AP group.
(AP group radio view) The undo wids device detect enable command disables device detection on all specified radios in an AP group.
(AP radio view) The wids device detect enable command enables device detection on an AP radio.
(AP radio view) The undo wids device detect enable command cancels the configuration of the device detection function on an AP radio. The status of this function on the AP radio is then determined by the status of this function in the AP group radio view.
By default, device detection is disabled on AP radios.
Usage Scenario
After the wireless device detection function is enabled, the monitoring AP detects information about wireless devices in its coverage range and reports the information to the AC. The AC determines whether unauthorized devices exist on the WLAN.
Precautions
The configuration in the AP radio view has a higher priority than that in the AP group radio view.
After the keep-service enable command is executed, if the wids device detect enable and wids contain enable commands are configured to enable rogue or interference device detection and containment, the AP will continue providing data services after going offline. However, the AC considers the AP as a rogue or interference device and adds it to the containment list. The containment mechanism will disconnect STAs from the AP. Therefore, service holding upon CAPWAP link disconnection does not take effect in this case.
After command keep-service enable allow new-access is executed, if the wids device detect enable and wids contain enable commands are configured to enable rogue or interference device detection and containment, the AP will continue providing data services after going offline. However, the AC considers the AP as a rogue or interference device and adds it to the containment list. The containment mechanism will disable the AP from allowing access of new STAs. Therefore, the function of enabling an offline AP to allow access of new STAs does not take effect in this case.
After the device detection function is enabled using this command, the detected data is stored only on the local device. To report the data to the iMaster NCE-Campus, run the collect-item user-data enable command in the SMI view to enable the device to report intelligent O&M data to the iMaster NCE-Campus.