display ac protect

Function

The display ac protect command displays AC dual-link backup configuration.

Format

display ac protect

Parameters

None

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

You can run this command to view AC dual-link backup configuration.

Example

# Display AC dual-link backup configuration.

<HUAWEI> display ac protect
------------------------------------------------------------
Protect state             : disable
Protect AC                : -
Priority                  : 0
Protect restore           : enable
Coldbackup kickoff station: disable
Alarm restrain            : disable
------------------------------------------------------------

**Table 1** Description of the **display ac protect** command output
Item	Description
Protect state	Whether global dual-link backup and N+1 backup are enabled. disable: Global dual-link backup is disabled, and N+1 backup is enabled. enable: Global dual-link backup is enabled, and N+1 backup is disabled. To configure the parameter, run the ac protect enable command.
Protect AC	Standby AC IP address. To configure the parameter, run the ac protect protect-ac command.
Priority	Priority of the local AC. To configure the parameter, run the ac protect priority command.
Protect restore	Whether global revertive switching is enabled on the AC. To configure the parameter, run the ac protect restore disable command.
Coldbackup kickoff station	Whether to enable the function of disconnecting STAs in open system authentication mode when an active/standby switchover is implemented between ACs that have dual-link cold backup configured. To configure the parameter, run the ac protect cold-backup kickoff-station command.
Alarm restrain	Whether to enable AP fault alarm suppression. To configure the parameter, run the ac protect alarm-restrain enable command.