display arp-miss speed-limit source-ip

Function

The display arp-miss speed-limit source-ip command displays the configuration of rate limit on ARP Miss message based on the source IP address.

Only the S5720-EI, S5720-HI, S5720I-SI, S5720S-SI, S5720-SI, S5735-L, S5735S-L, S5735S-L-M, S5735-S, S5735S-S, S5735-S-I, S5730-HI, S5730S-EI, S5730-SI, S5731-H, S5731-S, S5731S-H, S5731S-S, S5732-H, S6720-EI, S6720-HI, S6720-LI, S6720S-EI, S6720S-LI, S6720S-SI, S6720-SI, S6730-H, S6730S-H, S6730-S, and S6730S-S support this command.

Format

display arp-miss speed-limit source-ip

Parameters

None

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

After ARP Miss rate limiting based on source IP address is configured, you can run this command to check the configuration.

Example

# Display the configuration of rate limit on ARP Miss messages based on the source IP address.

<HUAWEI> display arp-miss speed-limit source-ip
 Slot     SuppressType   SuppressValue                                          
 ---------------------------------------------------                            
 0        ARP-miss       600

**Table 1** Description of the display arp-miss speed-limit source-ip command output
Item	Description
Slot	The value indicates the slot ID if stacking is not configured. The value indicates the stack ID if stacking is configured.
SuppressType	Suppression type.
SuppressValue	Maximum rate of ARP Miss messages from a specified source IP address. To configure a rate limit for ARP Miss messages based on the source IP address, run the arp-miss speed-limit source-ip command.