display auto-defend whitelist

Function

The display auto-defend whitelist command displays information about the attack source tracing whitelist.

Format

display auto-defend whitelist [ slot slot-id ]

Parameters

Parameter	Description	Value
slot slot-id	On a standalone switch without the stacking function configured, this parameter specifies a slot ID. In a stack system, this parameter specifies a stack ID.	Set the value according to the device configuration.

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

After the whitelist for attack source tracing is configured or when you locate faults on network, run the display auto-defend whitelist command to verify whitelist information. If no whitelist is configured, the command displays no whitelist information.

Example

# Display information about the attack source tracing whitelist on the switch.

<HUAWEI> display auto-defend whitelist
  Protocol       Interface                 IP                   ACL      Status
-------------------------------------------------------------------------------
    DHCP          GE0/0/1                  --                   --        auto
    DHCP          GE0/0/2                  --                   --        auto

**Table 1** Description of the **display auto-defend whitelist** command output
Item	Description
Protocol	Protocol type of the packets excluded from attack source tracing.
Interface	Interface on which inbound packets are excluded from attack source tracing.
IP	Source IP address of the packets excluded from attack source tracing. If not source IP address is specified in the whitelist rule, this field displays --.
ACL	ACL number specified in a manually configured whitelist rule. If the whitelist rule is automatically delivered, this field displays --.
Status	Type of the whitelist rule, which can be: auto: An automatically delivered whitelist rule is triggered by services. manual: You can run the auto-defend whitelist whitelist-number { acl acl-number \| interface interface-type interface-number } command in the attack defense policy view to manually configure an attack source tracing whitelist.