display default-parameter mrm

Function

The display default-parameter mrm command displays the default configurations for multicast routing management (MRM).

Format

display default-parameter mrm

Parameters

None

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

This command displays only the default configurations, regardless of whether MRM parameters are changed. Therefore, you can use this command to check which parameters have been modified.

Example

# Display default configurations for MRM.

<HUAWEI> display default-parameter mrm
  System View Default Configurations:
  -----------------------------------
  Load splitting rule: disabled
  Load-splitting-timer: 1800 s
  Route selection rule: preference-preferred
  Multi-topology: disabled

  Interface View Default Configurations:
  --------------------------------------
  Minimum TTL: 1
  Reject inbound data: disabled
  Reject outbound data: disabled
  Multicast load-splitting weight: 1

**Table 1** Description of the **display default-parameter mrm** command output
Item	Description
System View Default Configurations	Default configurations for multicast routing management (MRM) in the system view.
Load splitting rule	Whether multicast load splitting is configured. By default, multicast load splitting is not configured. To configure multicast load splitting, run the multicast load-splitting command.
Load-splitting-timer	Default value of the multicast load splitting balancing timer. By default, the value is 1800s. You can run the multicast load-splitting-timer command to set the value of the multicast load splitting balancing timer.
Route selection rule	RPF route selection rule. By default, RPF route selection is based on the preference of the routing protocol.
Interface View Default Configurations	Default configurations for multicast routing management (MRM) in the interface view.
Minimum TTL	Minimum TTL value for multicast packet forwarding.
Reject inbound data	Whether the interface is disabled from receiving multicast packets.
Reject outbound data	Whether the interface is disabled from forwarding multicast packets.
Multicast load-splitting weight	Multicast load splitting weight of the interface. By default, the multicast load splitting weight of an interface is 1. You can run the multicast load-splitting weight command to set the value of the multicast load splitting weight.