display default-parameter msdp

Function

The display default-parameter msdp command displays default configurations about MSDP.

Format

display default-parameter msdp

Parameters

None

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

This command still displays the default configurations even after the MSDP parameters are changed. You can use this command to check the consistency of default configurations about MSDP parameters on MSDP peers.

Example

# Display default configurations about MSDP.

<HUAWEI> display default-parameter msdp 
  MSDP View Default Configurations:                                             
  ---------------------------------                                             
  Cache-sa-enable: enabled                                                      
  Msdp description:                                                             
  Encap-data-enable: disabled                                                   
  Request-sa-enable: disabled                                                   
  Sa-request-policy: disabled                                                   
  Sa-policy: disabled                                                           
  Connect-retry-period: 30 s                                                    
  Minimum TTL: 0

Choose Columns...

**Table 1** Description of the **display default-parameter msdp** command output
Item	Description
MSDP View Default Configurations	Default configurations in the MSDP view.
Cache-sa-enable	Whether SA cache is enabled. By default, SA cache is enabled. This parameter is configured using the cache-sa-enable command.
Msdp description	Whether MSDP peer description is configured. By default, no description is configured for an MSDP peer. This parameter is configured using the peer description (MSDP) command.
Encap-data-enable	Whether encapsulating multicast data packets into the SA message is enabled. By default, an SA message does not encapsulate any multicast packet. This parameter is configured using the encap-data-enable command.
Request-sa-enable	Whether sending an SA Request message immediately when a Join message is received. By default, when receiving a Join message, the switch waits for the SA message in the next period instead of sending an SA Request message to its MSDP peer. This parameter is configured using the peer request-sa-enable command.
Sa-request-policy	Whether the filtering rule for responding to the SA Request message is configured. By default, the switch is not configured with any filtering rule for responding to the SA Request message and responds to all SA Request messages from all MSDP peers. This parameter is configured using the peer sa-request-policy command.
Sa-policy	Whether the filtering rule for receiving or forwarding the SA message is configured. By default, the switch does not filter the received or forwarded SA messages. This parameter is configured using the peer sa-policy command.
Connect-retry-period	Interval for retrying to set up a TCP connection between MSDP peers. By default, the interval for retrying to set up an MSDP peer relationship is 30 seconds. This parameter is configured using the timer retry command.
Minimum TTL	TTL value of SA messages that are encapsulated with multicast data. By default, the TTL value of SA messages that are encapsulated with multicast data is 0. This parameter is configured using the peer minimum-ttl command.