display trunk configuration

Function

The display trunk configuration command displays the maximum number of LAGs and the maximum number of member interfaces in each LAG.

Only the S5731-H, S5731-S, S5731S-H, S5731S-S, S5732-H, S6730-H, S6730S-H, S6730-S, S6730S-S, S6720-EI and S6720S-EI support this command.

Format

display trunk configuration

Parameters

None

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

To facilitate flexible networking, run the assign trunk command to set the maximum number of LAGs and the maximum number of member interfaces in each LAG. You can run the display trunk configuration command to view the configuration.

Example

# Display the maximum number of LAGs and the maximum number of member interfaces in each LAG.

<HUAWEI> display trunk configuration
--------------------------------------------------                              
Item            Default    Current    Configured                                
--------------------------------------------------                              
trunk-group     128        64         64                                         
trunk-member    8          16         16                                        
--------------------------------------------------

**Table 1** Description of the **display trunk configuration** command output
Item	Description
Item	The name of item.
Default	Default Eth-Trunk specifications supported by the device.
Current	Current Eth-Trunk specifications supported by the device.
Configured	Configured Eth-Trunk specifications. If the configured Eth-Trunk specifications are different from the current Eth-Trunk specifications, the configured Eth-Trunk specifications take effect after the device restarts. To specify the parameter, run the assign trunk command.
trunk-group	Maximum number of Eth-Trunks supported by the device.
trunk-member	Maximum number of member interfaces in each Eth-Trunk.