display loop-detect

Function

The display loop-detect command displays blocking information about L2VPN loop detection.

Format

display loop-detect

Parameters

None

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

After L2VPN loop detection is enabled on an interface by running the loop-detect enable command, you can run the display loop-detect command to check blocking information about L2VPN loop detection. The information helps determine whether loops occur on an L2VPN network, facilitating fault location.

Example

# Display blocking information about L2VPN loop detection on interfaces.

<HUAWEI> display loop-detect
----------------------------------------------------------------
Interface                     RecoverTime  Action      Status                      
-----------------------------------------------------------------
GigabitEthernet0/0/1.1       20           block       NORMAL                      
GigabitEthernet0/0/2.1       20           block       NORMAL                      
-----------------------------------------------------------------

**Table 1** Description of the **display loop-detect** command output
Item	Description
Interface	Interface with L2VPN loop detection enabled. To enable L2VPN loop detection on an interface, run the loop-detect enable command.
RecoverTime	Period for restoring an interface to normal state. To specify this period, run the loop-detect recovery-time command.
Action	Action after an L2VPN loop is detected: BLOCK: Block this interface.
Status	Status of an interface with L2VPN loop detection enabled: NORMAL: No loop is detected. BLOCK: A loop is detected, and the interface is blocked.