display ospfv3 vlink

Function

The display ospfv3 vlink command displays the OSPFv3 virtual links.

Format

display ospfv3 [ process-id ] vlink

Parameters

Parameter	Description	Value
process-id	Identifies the OSPFv3 process ID.	The value ranges from 1 to 65535.

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

You can run the display ospfv3 vlink command to check the OSPFv3 virtual links.

Example

# Display OSPFv3 virtual links.

<HUAWEI> display ospfv3 vlink

OSPFv3 Process (100)                        
                    
Virtual Link VLINK1 to router 10.2.2.2 is up
 Transit area 0.0.0.1 via interface Vlanif10, instance ID 0
 Local address FC00:0:0:2000::1
 Remote address FC00:0:0:1001::2
 Interface ID 0x80000001
 VirtualInterface Event: 1
 VirtualInterface LsaCount: 0
 VirtualInterface Lsa Checksum: 0x0
 Transmit Delay is 1 sec, State Point-To-Point, Cost 1562
 Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
      Hello due in 00:00:04
   Adjacency state Init

**Table 1** Description of the **display ospfv3 vlink** command output
Item	Description
Transit area	If the current interface is the V-link interface, the transfer area ID is displayed
via interface	Interface of the V-link
instance ID	Instance ID
Local address	Local address
Remote address	Remote address
Interface ID	Interface ID
VirtualInterface Event	Number of interface events of the V-link
VirtualInterface LsaCount	Number of LSAs sent from all V-link interfaces
VirtualInterface Lsa Checksum	Checksum of the LSA sent from the V-link interface
Transmit Delay	Transmission delay of the interface
State	Interface state: Down Point-To-Point
Cost	Cost
Timer intervals configured	Timers: Hello: Hello interval Dead: Interval of Dead timer Wait: Interval of Wait timer. It is pointless to use a virtual link. Retransmit: Retransmission interval
Adjacency state	State of the V-link: Down Init Exch Start Exchange Loading Full