display rmon2 protocoldirtable

Function

The display rmon2 protocoldirtable command displays all entries in the protocolDirTable.

Format

display rmon2 protocoldirtable

Parameters

None

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

After you use the rmon2 protocoldirtable command to configure statistics on IP packets, you can run the display rmon2 protocoldirtable command to view the configurations.

Example

# Display entries in the protocolDirTable.

<HUAWEI> display rmon2 protocoldirtable
protocolDirId              :   8.0.0.0.1.0.0.8.0
protocolDirParameters      :   2.0.0
protocolDirLocalIndex      :   2
protocolDirDescr           :   ww
protocolDirAddressMapConfig:   not supported
protocolDirHostConfig      :   supported on
protocolDirMatrixConfig    :   not supported
protocolDirOwner           :   huawei
protocolDirStatus          :   active

**Table 1** Description of the display rmon2 protocoldirtable command output
Item	Description
protocolDirId	Protocol directory ID. Currently, RMON2 only supports IP protocol, so the protocol directory ID is fixed at 8.0.0.0.1.0.0.8.0.
protocolDirParameters	Protocol directory parameter. The value is fixed at 2.0.0.
protocolDirLocalIndex	Local protocol directory index.
protocolDirDescr	Indicates the description of the protocol directory table. You can run the rmon2 protocoldirtable command to configure this parameter.
protocolDirAddressMapConfig	Whether protocol directory address mapping is supported. This function is not supported currently.
protocolDirHostConfig	Whether the configuration of protocol directory host is supported: not supported: The device does not monitor the network-layer host table of the protocol, and this value cannot be changed. supported on: The device can monitor the network-layer host table of the protocol, and the monitoring function is enabled. supported off: The device can monitor the network-layer host table of the protocol, but the monitoring function is disabled. You can run the rmon2 protocoldirtable command to configure this parameter.
protocolDirMatrixConfig	Whether protocol directory matrix is supported. This function is not supported currently.
protocolDirOwner	Indicates the owner. You can run the rmon2 protocoldirtable command to configure this parameter.
protocolDirStatus	Protocol directory status. active: running normally not in service: invalid You can run the rmon2 protocoldirtable command to configure this parameter.