display this include-default
Function
The display this include-default command displays the valid configurations in the current view, including the unchanged default configurations.
This command does not display the default configurations that are not modified in the WLAN view.
Usage Guidelines
- VLAN management: port-based VLAN assignment, other VLAN assignment methods, PVID, link type, QinQ protocol type, port priority, discard tagged-pkt, and port bridge
- MUX VLAN, voice VLAN, VLAN mapping/stacking, VT enable, and VT miss-drop
- MAC address learning status and priority, port security, sticky MAC, MAC address limiting, and MAC flapping detection
- MSTP, L2PT, DLDP, LLDP, loopback detection, RRPP, SmartLink, SEP, and ERPS
- Ethernet interface physical attributes: speed/duplex, speed auto-negotiation, negotiation, flow control, flow control negotiation, flow-control receive/flow-control negotiation receive, loopback, MDI, jumbo frame, trap/log alarm thresholds, link flapping, EEE, link Up/Down report delay, VCT, inter-frame gap statistics, error packet statistics, URPF, and copper module information
- ARP, ND, Eth-Trunk, and port isolation
- BFD: single-hop BFD, multi-hop BFD, BFD for LSP, and multicast BFD
- Unicast route management, static routes, RIP, OSPF, IS-IS, BGP, and VRRP
- Multicast routing, PIM, IGMP, MLD, IGMP snooping, and MLD snooping
- QoS, ACL, storm suppression, ARP security, IP security, and MFF
- DHCP, DHCPv6, ND Snooping, NAC, and RADIUS
This command can also display the following default global configurations: enabling of the function that sends ICMP host/port unreachable packets, enabling of the function that discards ICMP packets with TTL value 1, rate limit for ARP Miss packets, enabling of ICMP packet rate limiting, and interval for collecting CAR-based traffic statistics. For the support for default settings of the features, see the corresponding device model.
Example
# Display the valid configurations and default configurations on VLANIF 10. The following command output is used for reference. The command output on your device may differ from that provided in this example.
[HUAWEI] interface Vlanif 10 [HUAWEI-Vlanif10] display this include-default # interface Vlanif10 undo shutdown undo set flow-stat interval mtu 1500 undo arp detect-mode unicast arp-fake expire-time 3 undo arp learning disable undo arp purge slowly undo ipv6 enable icmp host-unreachable send icmp redirect send icmp port-unreachable send icmp ttl-exceeded send undo ip verify source-address undo ip forward-broadcast undo clear ip df undo discard srr undo discard rr undo discard ra undo discard ts damping time 0 arp learning strict trust undo ntp-service in-interface disable undo mpls undo arp-proxy enable undo arp-proxy inter-sub-vlan-proxy enable undo arp-proxy inner-sub-vlan-proxy enable undo arp broadcast disable undo rrpp snooping enable nd optimized-passby enable undo urpf diffserv-mode uniform undo statistic enable both undo ipv4 statistic enable both undo ipv6 statistic enable both undo arp gratuitous-arp send enable undo arp anti-attack entry-check enable undo arp learning double-tag disable arp optimized-passby enable undo dhcp select global undo dhcp select interface undo dhcp select relay undo ip address bootp-alloc undo ip address dhcp-alloc undo arp learning dhcp-trigger # return