dldp compatible-mode enable

Function

The dldp compatible-mode enable command enables the DLDP compatible mode.

The undo dldp compatible-mode enable command disables the DLDP compatible mode.

By default, the DLDP compatible mode is disabled.

Format

dldp compatible-mode enable

undo dldp compatible-mode enable

Parameters

None

Views

Ethernet interface view, GE interface view, XGE interface view, 25GE interface view, 40GE interface view, 100GE interface view, MultiGE interface view, port group view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

This configuration is required if the device works with the following Huawei switches to provide the DLDP function:

S8500
S7800
S6500
S5600 series
S5100-EI
S3900 series
S3500 series
S3100 series

Prerequisites

DLDP has been enabled globally using the dldp enable command.

Precautions

If two devices are connected by two cross-connected links, the DLDP compatible mode must be enabled or disabled on both the two interfaces.

If two devices are Huawei devices (not preceding models), the DLDP compatible mode must be enabled or disabled on both the two interfaces.

Example

# Enable the DLDP compatible mode on interfaceGE0/0/1.

<HUAWEI> system-view
[HUAWEI] dldp enable
[HUAWEI] interface gigabitethernet 0/0/1
[HUAWEI-GigabitEthernet0/0/1] dldp enable
[HUAWEI-GigabitEthernet0/0/1] dldp compatible-mode enable