ecmp load-balance

Function

The ecmp load-balance command sets the ECMP load balancing mode.

The undo ecmp load-balance command deletes the configured ECMP load balancing mode.

By default, ECMP load balancing is performed on packets based on the source IP address, destination IP address, transport-layer source port number and destination port number.

Product	Support
S5720-EI, S5720-HI, S5730-HI, S5731-S, S5731S-S, S5731-H, S5731S-H, S5732-H, S5735-S, S5735S-S, S5735-S-I, S6720-EI, S6720-HI, S6720S-EI, S6730S-H, S6730-H, S6730-S, and S6730S-S	Supported
S2720-EI, S5720I-SI, S5720-LI, S5735-L, S5735S-L, S5735S-L-M, S5720S-LI, S5720S-SI, S5720-SI, S5730S-EI, S5730-SI, S6720-LI, S6720S-LI, S6720-SI, and S6720S-SI,	Not supported

Format

ecmp load-balance sip [ dip ] [ port ]

undo ecmp load-balance sip [ dip ] [ port ]

Parameters

Parameter	Description	Value
sip	Configures ECMP load balancing based on the source IP address.	-
dip	Configures ECMP load balancing based on the destination IP address.	-
port	Configures ECMP load balancing based on the transport-layer source port number and destination port number.	-

Views

System view

Default Level

2: Configuration level

Usage Guidelines

If you run the ecmp load-balance command in the system view multiple times, only the latest configuration takes effect.

Example

# Configure ECMP load balancing based on the source IP address.

<HUAWEI> system-view
[HUAWEI] ecmp load-balance sip