error-shutdown auto-recovery interval (upgrade-compatible command)

Function

The error-shutdown auto-recovery interval command sets the auto recovery delay.

An interface enters the error-shutdown state after being shut down due to an error.

Format

error-shutdown auto-recovery interval interval-value

Parameters

Parameter	Description	Value
interval interval-value	Specifies the auto recovery delay.	The value is an integer that ranges from 30 to 86400, in seconds. A smaller value indicates a higher frequency at which an interface alternates between Up and Down states. A larger value indicates longer traffic interruption.

Views

System view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

By default, an interface can only be resumed by a network administrator after being shut down. To configure the interface to restore to the Up state automatically, run the error-shutdown auto-recovery interval command to set an auto recovery delay. After the delay, the interface goes Up automatically.

Example

# Set the auto recovery delay to 50s.

<HUAWEI> system-view
[HUAWEI] error-shutdown auto-recovery interval 50