lacp collector delay

Function

The lacp collector delay command configures the value of the CollectorMaxDelay field in an LACPDU.

The undo lacp collector delay command restores the default value of the CollectorMaxDelay field in an LACPDU.

The default value of the CollectorMaxDelay field is 0 in an LACPDU.

Format

lacp collector delay delay-time

undo lacp collector delay

Parameters

Parameter	Description	Value
delay-time	Specifies the value of the CollectorMaxDelay field in an LACPDU.	The value is an integer that ranges from 0 to 65535, in 10 microseconds.

Views

Eth-Trunk interface view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

The default value of the CollectorMaxDelay field in LACPDUs sent by the device of different versions to the connected non-Huawei device is different. This may cause high CPU usage. You can run the lacp collector delay command to set the value of the CollectorMaxDelay field in LACPDUs.

Prerequisites

The Eth-Trunk has been configured to work in LACP mode using the mode lacp command.

Precautions

For a Huawei device, the valid value range of the CollectorMaxDelay field is 0 to 65535. Even though the member interfaces of the same Eth-Trunk receive LACPDUs with different CollectorMaxDelay values, the device can process the LACPDUs without deteriorating its CPU performance.

Example

# Set the value of the CollectorMaxDelay field to 65535.

<HUAWEI> system-view

[HUAWEI] interface eth-trunk 1

[HUAWEI-Eth-Trunk1] mode lacp

[HUAWEI-Eth-Trunk1] lacp collector delay 65535