lacp e-trunk system-id (Eth-Trunk interface view) (upgrade-compatible command)

Function

The lacp e-trunk system-id command configures the Link Aggregation Control Protocol (LACP) system ID of an E-Trunk.

The undo lacp e-trunk system-id command deletes the LACP system ID of an E-Trunk.

By default, the LACP system ID is the Ethernet MAC address of the device.

lacp e-trunk system-id mac-address

undo lacp e-trunk system-id

Parameter	Description	Value
system-id mac-address	Specifies the LACP system ID of the E-Trunk.	The value is in the format of H-H-H. An H contains 1 to 4 hexadecimal digits, such as 00e0 and fc01. If an H contains fewer than four digits, 0s are padded ahead. For example, if an H is specified as e0, it is displayed as 00e0. The LACP system ID cannot be all 0s or all Fs. NOTE: The LACP system ID cannot be all 0s. If the value is all Fs, it indicates that the LACP system ID is restored to the default.

Eth-Trunk interface view

2: Configuration level

This command is available to aid upgrade compatibility. It can only be run during the configuration restoration phase of the upgrade.

It is replaced by the lacp system-id mac-address command.